1 of 1

Access to the server

Prepare your receiver and access the configuration server

Receiver preparation

Step 1 : Connect an antenna to the receiver

First of all, don't forget to connect the long-range antenna to the SMA connector of the receiver.

Step 2 : Power the receiver (7.5 - 24VDC)

Open the receiver case by unscrewing the 4 cover screws.
Externally power your receiver (between 7.5 and 24VDC). If you use our 12V power supply, connect your power supply to the POWER terminal of the receiver.

• Red wire connected to the V+ terminal block

• Black wire connected to the 0V terminal block

The LED C should light up when your receiver is properly powered.

Consumption is normally less than 50mA at 12V. During the sensor installation phase, there may be peaks at 500mA. To avoid any problems please maintain 1A 12V on the power terminal block

Step 3 : Connect the receiver via Ethernet to the PC

The receiver is supplied without RJ45 cable. You need to obtain an RJ45 cable to continue the installation. Connect the RJ45 cable to the port on your receiver and also to the Ethernet port on your PC.

If your PC does not have an Ethernet port, we invite you to use a USB / Ethernet adapter.

Step 4 : Validate the receiver LED behavior

Once your receiver is powered and connected to your PC, you can validate the correct behavior of the product using its LEDs. Description of LEDs here .

Access to the receiver server

Once your receiver is powered and connected to your PC, you will be able to access its configuration server. From your browser, enter the address 192.168.77.77 to access the server.

If you want to change the receiver IP address, please see this article.