Below is a table showing the battery reference to use for each sensor.
| Type | Battery C | Battery D | Battery D | Battery D |
|---|---|---|---|---|
Risk of explosion if sensor batteries are replaced with an incorrect reference.
Disconnect the Molex connector of the used battery from the PCB connector
Remove the used battery from its slot
Insert the new battery in the slot
Reconnect the new battery Molex connector to the PCB connector
The sensor restarts.
Disconnect the used battery Molex connector from the PCB connector
Unscrew the screws on the battery clip
Remove the battery clip
Remove the used battery from its slot
Insert the new battery in the slot
Replace the battery clip
Secure the battery clip with the two screws provided
Reconnect the new battery Molex connector to the PCB connector
The sensor restarts.
Do not throw the battery into the fire.
Do not short-circuit the battery.
Do not crush the battery.
Sensor
1000-028 (ER26500)
1000-029 (ER34615)
1000-030 (ER34615)
1000-031 (ER34615)
TX T&H AMB
600-021/600-121
X
TX CO2 VOC T&H AMB
600-023/600-123
X
TX TEMP INS
600-031/600-131
X
TX TEMP CONT1
600-032/600-132
X
TX TEMP CONT2
600-232/600-332
X
TX T&H EXT
600-034/600-134
X
TX 4/20
600-035/600-135
X
TX PULSE
600-036/600-136
X
TX PULSE ATEX
600-037
X
TX PULSE LED
600-038/600-138
X
TX CONTACT
600-039/600-139
X