Configure the Modbus receiver communication parameters from the CONFIG RX tab
Configuration of the Modbus receiver parameters is done from the CONFIG RX tab
Once the receiver configuration is complete, you can click on the MODBUS tab to access the receiver table. When you select a transmitter on the left of the screen, the registers in which its information is stored are displayed in the Modbus Table. You can save this Modbus table with the “Export CSV»
The Excel file detailing the receiver's Modbus table is available below.
We recommend that the Modbus request frequency on our Modbus receivers falls no lower than 5 seconds between each request.
| Field | Meaning |
|---|---|
Match the receiver's communication settings with those of your controller.
Modbus ID of the receiver.
Register number from which the sensor information will be incremented in the Modbus table.
Determine the receiver's communication interface when you want to communicate via Modbus RTU: RS232 or RS485
IP parameters for Modbus TCP/IP communication
Baud rate, Data and stop bits, Parity
Modbus ID
1st register
RS232 / RS485
Advanced settings
