L1
Always ON
Powered sensor
L2
ON
Installation failed
L3
ON
Successful installation but weak radio signal
L4
ON
Successful installation and good signal
LEDs behavior of Enless sensors
| LED | Behavior |
|---|---|
| Installation status | Behavior of L1 | Behavior of L2 | Behavior of L3 |
|---|---|---|---|
| LED | Behavior |
|---|---|
Do not power the sensors simultaneously. Power them one by one and wait for the previous one to be correctly activated before powering the next one.
L1
Flash every 5s
L2
Flash when the sensor sends a message
L3
Flash when the receiver responds
L1
L2
L3
Success strong signal
OFF
OFF
ON (30s)
Success weak signal
OFF
ON (30s)
OFF
Installation failed
ON (30s)
OFF
OFF
L1
Flash every 1 minute in the event of an alarm
L2
Flash on each frame send
L3
Flash every 1 minute
The description of the LED behavior for Enless products is given below
A
Flash
The receiver has received a message
B
Flash
The receiver has sent a message
C
ON
The receiver is correctly powered
D
Flash
Communication message transmitted
E
Flash
Communication message received
F
OFF
LED not used
Exterior red
Flash Every 1 minute
The receiver is in operation
Green Ethernet port
Flash
The receiver connects to the Ethernet network
Orange Ethernet port
Flash
The receiver sends information to the Ethernet network
A
OFF
B
OFF
C
Flash every 5 seconds
D
Flash when a message is sent
ON for 30 secs if installation successful but weak signal
E
Flash when a message is received
ON for 30 secs if installation successful
F
OFF during installation sequence
ON for 30 secs if installation fails
A
Flash when message is sent on Comms
B
Flash when a message is received on Comms
C
ON
D
Flash when message is sent over RF
E
Flash when message is received over RF
F
OFF
A | Flash | The repeater has received a message |
B | Flash | The repeater has transmitted a message |
C | ON | The repeater is correctly powered |
Exterior red | Flash Every 1 minute | The repeater is in operation |
