Power the sensors so they pair with the receiver.
Open the sensor boxes that you have just declared and that you wish to activate.
Check that the sensors are in proprietary LoRa mode. Validate that the jumper of each sensor is correctly positioned on the two pins and that it is in proprietary LoRa mode ( see appendix ). If this is not the case, please position the jumper correctly before proceeding to activate the products.
Power the first sensor (of your choice) by connecting the Molex connector.
Monitor the sensor LED behavior. A LED L3 fixed will confirm that the sensor is correctly paired to the receiver. Repeat for all sensors to activate.
In the CONFIG TX tab, refresh the page in your browser.
A validation sticker should appear in front of the sensor(s) you have just activated. A red dot means that the configuration is being recovered. Do not hesitate to wait a few moments and refresh your page if the green dots do not appear.
