Configure the BACnet receiver communication parameters from the CONFIG RX tab
If you want to configure a Modbus receiver, go to the Modbus receiver communication settings page .
The configuration of the BACnet receiver parameters is done from the CONFIG RX tab
| Field | Meaning |
|---|---|
Match the receiver's communication parameters with those of your PLC (valid for BACnet MSTP communication).
Each sensor paired to the receiver will appear as a BACnet device on the network during discover. Only objects from sensors paired to the receiver will be accessible after the .
The receiver will display any BACnet objects it may contain during .
Select the desired communication protocol:
MSTP
IP
MSTP + BBMD
IP+ MSTP
You can enable (or not) DHCP
Additional parameters (IP address, subnet mask, gateway, UDP port...)
Baud rate, Data and stop bits, Parity
Device mode
Object mode
Protocole
DHCP
Other settings
