Configure the Modbus receiver communication parameters from the CONFIG RX tab
Configuration of the Modbus receiver parameters is done from the CONFIG RX tab
Once the receiver configuration is complete, you can click on the MODBUS tab to access the receiver table. When you select a transmitter on the left of the screen, the registers in which its information is stored are displayed in the Modbus Table. You can save this Modbus table with the “Export CSV»
The Excel file detailing the receiver's Modbus table is available below.
We recommend that the Modbus request frequency on our Modbus receivers falls no lower than 5 seconds between each request.
| Field | Meaning |
|---|---|
Match the receiver's communication settings with those of your controller.
Modbus ID of the receiver.
Register number from which the sensor information will be incremented in the Modbus table.
Determine the receiver's communication interface when you want to communicate via Modbus RTU: RS232 or RS485
IP parameters for Modbus TCP/IP communication
Configure the BACnet receiver communication parameters from the CONFIG RX tab
If you want to configure a Modbus receiver, go to the Modbus receiver communication settings page .
The configuration of the BACnet receiver parameters is done from the CONFIG RX tab
Configure the communication parameters of your receiver from the CONFIG RX tab
Once the configuration and activation of the sensors is complete, the last phase consists of determining the communication parameters of the receiver before connecting it to the BMS.
The configuration options will therefore be different depending on the type of receiver you are using (Modbus or BACnet). Choose the receiver you want to configure below.
Baud rate, Data and stop bits, Parity
Modbus ID
1st register
RS232 / RS485
Advanced settings
| Field | Meaning |
|---|---|
Match the receiver's communication parameters with those of your PLC (valid for BACnet MSTP communication).
Each sensor paired to the receiver will appear as a BACnet device on the network during discover. Only objects from sensors paired to the receiver will be accessible after the .
The receiver will display any BACnet objects it may contain during .
Select the desired communication protocol:
MSTP
IP
MSTP + BBMD
IP+ MSTP
You can enable (or not) DHCP
Additional parameters (IP address, subnet mask, gateway, UDP port...)
Baud rate, Data and stop bits, Parity
Device mode
Object mode
Protocole
DHCP
Other settings
