Installation guide LoRaWAN
  • Installation help guide
  • About LoRaWAN
  • Installation steps
  • Information concerning the sensors
  • Installation
    • Sensors' provisioning
    • Activation of sensors
    • Configuration of downlinks
    • Validation of data reception
    • Installation of sensors
    • Payload decoding
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎Communication mode
    • 📎Validation of LED behavior
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Installation

Validation of data reception

Validate that messages are correctly received on the LoRaWAN network


Before moving on to the installation and fixing of the products, we invite you to validate from the cloud or the gateway that the sensor frames are received, and at the correct frequency.

If necessary, a push button to force the sending of test frames is available on the electronic card of each transmitter.

PreviousConfiguration of downlinksNextInstallation of sensors

Last updated 7 months ago

Was this helpful?