📎Communication Modes

LoRaWAN vs LoRa proprietary

This documentation outlines the installation procedure for sensors operating in LoRaWAN mode. Therefore, it is essential that the sensors you are using are configured to communicate in LoRaWAN mode. The communication mode can be selected either via a jumper on the sensor’s circuit board or using a switch located on the back of the device (depending on the sensor model).

See example below:

Next-generation room sensors Switch on the back of the device set to WAN position

Next-generation mini room sensors Switch on the back of the device set to WAN positionWAN

Rugged sensors Jumper on the circuit board positioned on a single pin

Ambient sensors Jumper on the circuit board positioned on a single pin

The mode change will only be taken into account if the jumper/rotary switching is carried out when the sensor is depowered.