Different configuration options from the sensor’s switch
When operating the sensors in LoRaWAN mode, the switch on the back of the device can be used to pre-configure specific parameters. The switch position must be defined before powering up the sensors.
Options
Switch in position WAN
The sensor operates in LoRaWAN communication mode (default transmission period: 15 minutes)
Switch in position A
The sensor operates in LoRaWAN mode with a transmission period of 30 minutes
Switch in position B
The sensor operates in LoRaWAN mode with a transmission period of 1 hour
Switch in position C
The sensor operates in LoRaWAN mode, with a transmission period of 1 hour and data logging of temperature and humidity every 5 minutes.
Note: this combination is supported only by the following sensors:
