Ambient & Room Control Sensors
How to mount ambient and room control sensors on the wall
TX T&H AMB 600-051 You can install the sensor on the wall either by fastening the back plate with screws (not included with the product) or by using the 3M adhesive (provided with the product)
TX T&H E-INK AMB 600-052 You can install the sensor on the wall either by fastening the back plate with screws (not included with the product) or by using the 3M adhesive (provided with the product)
TX CO2 T&H AMB 600-053 You can install the sensor on the wall either by fastening the back plate with screws (not included with the product) or by using the 3M adhesive (provided with the product)
TX T&H AMB 600-021 Wall mounting is done by screwing the product in place. To do so, open the product’s cover to access the screw hole, then fasten the sensor to the wall from inside the product.
TX CO2 T&H AMB 600-023 Wall mounting is done by screwing the product in place. To do so, open the product’s cover to access the screw hole, then fasten the sensor to the wall from inside the product.
Last updated
Was this helpful?