Installation guide LoRaWAN
  • Installation help guide
  • About LoRaWAN
  • Installation steps
  • Information concerning the sensors
  • Installation
    • Sensors' provisioning
    • Activation of sensors
    • Configuration of downlinks
    • Validation of data reception
    • Installation of sensors
    • Payload decoding
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎Communication mode
    • 📎Validation of LED behavior
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page
  • EU868 Range
  • US915 Range

Was this helpful?

Export as PDF
  1. Appendices

Applicability

This guide is applicable to devices listed below.

EU868 Range

  • TX T&H AMB 600-021

  • TX CO2/VOC/T&H AMB 600-023

  • TX TEMP INS 600-031

  • TX TEMP CONT1 600-032

  • TX TEMP CONT2 600-232

  • TX T&H EXT 600-034

  • TX 4/20 mA 600-035

  • TX PULSE 600-036

  • TX PULSE ATEX 600-037

  • TX PULSE LED 600-038

  • TX CONTACT 600-039

US915 Range

  • TX T&H AMB 600-121

  • TX CO2/VOC/T&H AMB 600-123

  • TX TEMP INS 600-131

  • TX TEMP CONT1 600-132

  • TX TEMP CONT2 600-332

  • TX T&H EXT 600-134

  • TX 4/20 mA 600-135

  • TX PULSE 600-136

  • TX PULSE LED 600-138

  • TX CONTACT 600-139

PreviousPayload decodingNextSafety

Last updated 11 months ago

Was this helpful?

📂
📎