📎Communication mode

LoRaWAN vs LoRa proprietary

This document described the procedure for installing sensors in LoRaWAN mode. The sensors you use must therefore communicate in the LoRaWAN mode.

The communication mode is selected by means of a jumper on the electronic board in each sensor. See example below

Example below :

LoRaWAN mode Jumper positioned on a single pin.
Proprietary LoRa mode Jumper positioned on the two pins.

The mode change will only be taken into account if the jumper switching is carried out when the sensor is depowered.

Last updated

Was this helpful?