📎Validation of LED behavior

LED behavior of Enless sensors

---

Phase 1 : Starting the sensor

LED	Behavior
L1 L2 L3 + WAN	Flash successively
L2	Flash when sensor sends a message

Phase 2 : Installation status

Installation status	Behavior of L1	Behavior of L2	Behavior of L3
	L1	L2	L3
Success strong signal	OFF	OFF	ON (30s)
Success weak signal	OFF	ON (30s)	OFF
Installation failed	ON (30s)	OFF	OFF

Phase 3 : Operation

LED	Behavior
L1	Flash every 1 minute in the event of an alarm
L2	Flash on each frame send
L3	Flash every 1 minute

Do not power the sensors simultaneously. Power them one by one and wait for the previous one to be correctly activated before powering the next one.