Activation of sensors

Power the sensors so they pair with the LoRaWAN network.


Once the transmitters have been declared using the keys on the cloud or the gateway, the LoRaWAN transmitters must be powered up to dialogue with the network.

Verify that the transmitters are in LoRaWAN mode. Validate that the jumper of each transmitter is correctly positioned on a single pin and that it is in LoRaWAN mode (see appendix). If this is not the case, please position the jumper correctly before proceeding with product activation.

Step 1 : Open the sensor housing

Open the boxes of the sensors that you have just declared and that you wish to activate.

Step 2 : Power the sensors

Power the first transmitter (of your choice) by connecting the Molex connector.

Step 3 : Validate the sensor LED behavior

The behavior of sensor LEDs is described in the appendix

Last updated

Was this helpful?