Installation guide LoRa proprietary
search
⌘Ctrlk
Installation guide LoRa proprietary
  • Getting Started
    • book-openInstallation Guide
    • circle-infoAbout Proprietary LoRa
    • arrow-progressInstallation Steps
  • Installation
    • network-wiredIP Configuration
    • displayAccess to the Server
    • uploadReceiver Update (optional)
    • gearSensor Configuration
    • circle-checkSensor Activation
    • wifiData Reception
    • wrenchSensor Installation
    • slidersReceiver Settings
    • diagram-nestedReceiver Connection to the Controller
    • comment-questionTroubleshooting
  • TX IO INSTALLATION
    • hand-point-rightInstallation Procedure
  • TX MODBUS INSTALLATION
    • hand-point-rightInstallation Procedure
  • 📂Appendices
    • 📎Best Radio Practices
    • 📎Communication Modes
    • 📎Using the Push Button
    • 📎LED Sequence Meanings
    • 📎CO2 Sensor Calibration
    • 📎Wiring
      • Wiring Diagrams
      • Pulse sensors wiring
      • 4/20mA Probe Wiring
    • 📎RESET to Factory Settings
    • 📎Repeater Installation
    • 📎Sensor Update
    • 📎Batteries
    • 📎Generic Information
gitbookPowered by GitBook
block-quoteOn this pagechevron-down
  1. 📂Appendices

📎Wiring

Wiring Diagramschevron-rightPulse sensors wiringchevron-right4/20mA Probe Wiringchevron-right
PreviousCO2 Sensor Calibrationchevron-leftNextWiring Diagramschevron-right

Was this helpful?

Was this helpful?