Sensor Activation

Power the sensors so they pair with the receiver.

1

Check that the sensors are in Proprietary LoRa mode

Make sure the sensors are set to Proprietary LoRa mode. Check that the product's jumper or switch is correctly positioned for Proprietary LoRa mode (see appendix). If not, please set it correctly before proceeding with sensor activation.

2

Power the sensors

Power the first sensor (any one of your choice) by connecting its battery. The powering method may vary depending on the type of sensor you are using.

New-generation sensors are equipped with supercapacitors to optimize battery life. As a result, when you remove the battery’s insulating tab, it may take around 5 seconds (the time needed for the supercapacitor to charge) before the first LEDs start flashing.

3

Monitor the sensor LED sequence

When the sensor attempts to connect to the receiver, its LEDs will start flashing. It takes approximately 30 seconds for the sensor to connect to the receiver. A solid green LED indicates that the sensor has been successfully paired. Repeat this process for all sensors you wish to activate.

For more details on the sensor LED sequences, see: LED Sequence Meanings.

4

Validate sensor activation from the server

In the CONFIG TX tab, refresh your browser page. A green status indicator should appear next to the sensors you have just activated. A red indicator means the configuration is still being retrieved. Feel free to wait a few moments and refresh the page again if the green indicators do not appear right away.