Access to the Server

Prepare your receiver and access the configuration server

Receiver Preparation

Step 1 : Connect an antenna to the receiver

First, make sure to connect the long-range antenna to the receiver's SMA connector.

Step 2 : Power the receiver (7.5 - 24VDC)

1. Open the receiver casing by unscrewing the four cover screws.

2. Power the receiver externally (between 7.5 and 24 VDC). If you are using our 12V power supply, connect it to the POWER terminal of the receiver.

• Red wire connected to the V+ terminal block

• Black wire connected to the 0V terminal block

The LED C should light up when your receiver is properly powered.

Power consumption is typically below 50 mA at 12 V. However, during the sensor installation phase, current peaks may reach up to 500 mA. To avoid any issues, we recommend providing a 12 V / 1 A power supply to the receiver’s terminal block.

Step 3 : Connect the receiver to the PC via Ethernet.

The receiver is supplied without an RJ45 cable. You will need to obtain one to proceed with the installation. Connect the RJ45 cable to the port on the receiver and to the Ethernet port on your PC.

If your PC does not have an Ethernet port, we invite you to use a USB / Ethernet adapter.

Step 4 : Validate the receiver LED behavior

Once your receiver is powered and connected to your PC, you can validate the correct behavior of the product using its LEDs. Description of LEDs here .

Accessing the Receiver’s Server

Once your receiver is powered and connected to your PC, you can access its configuration server. In your browser, enter the address 192.168.77.77 to access the server. We recommend using Google Chrome for optimal compatibility with the configuration server.

IIf you wish to change the receiver’s IP address, please refer to this article.