Installation guide LoRa proprietary
  • Installation help guide
  • About proprietary LoRa
  • Installation steps
  • Installation
    • IP Configuration
    • Access to the server
    • Receiver update (optional)
    • Configuring sensors
    • Activation of sensors
    • Data reception
    • Installation of devices
    • Receiver settings
      • Modbus receiver communication parameters
      • BACnet receiver communication parameters
    • Connecting the receiver to the PLC or the BMS
    • ⚠️Recommendations
  • INSTALLATION TX IO
    • Installation procedure
      • Reminder
      • Remote control mode
      • Local control mode
      • D2D mode
  • INSTALLATION TX MODBUS
    • Installation procedure
      • Reminder
      • Configuration
      • Activation of TX MODBUS
      • Checking
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎LED behavior
      • 🖇️Sensors
      • 🖇️TX IO
      • 🖇️TX Modbus
      • 🖇️Modbus & BACnet receivers
      • 🖇️Repeater
    • 📎Communication mode
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Repeater installation
    • 📎RESET factory settings
    • 📎Wiring diagrams
      • RX MODBUS 500-302
      • RX BACNET 500-312
      • TX MODBUS 600-041
      • TX IO 600-040
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page
  • Position your repeater
  • Power your repeater
  • Meaning of the repeater LEDs

Was this helpful?

Export as PDF
  1. Appendices

Repeater installation

RX REPEATER 600-301

Previous4/20mA probe wiringNextRESET factory settings

Last updated 6 months ago

Was this helpful?

One or more sensors remain out of range of the receiver: you will have to install a repeater. The repeater requires no configuration.

Position your repeater

We recommend positioning your repeater halfway between the transmitters and the Modbus receiver. The repeater comes with a 1/4 wave antenna but you can also use a long range antenna to maximize the performance of the repeater. You can chain several repeaters together.

Power your repeater

Once positioned, power the repeater. The repeater can be powered either:

• By a 12V power box

• By a main power supply of 7.5 to 24VDC.

Current characteristic for powering the repeater at 12Vdc: 1A max. Use only CE certified 12V power supply

In both cases, the wires will be connected to the POWER terminal block of the repeater:

• Black wire connected to the 0V terminal block

• Red wire connected to the V+ terminal block

Meaning of the repeater LEDs

The repeater LED behavior is documented

On the configuration server, frames passing through a repeater indicate (R) next to the RSSI signal value.

📂
📎
here