Installation guide LoRa proprietary
CtrlK
  • Getting Started
    • Installation Guide
    • About Proprietary LoRa
    • Installation Steps
  • Installation
    • IP Configuration
    • Access to the Server
    • Receiver Update (optional)
    • Sensor Configuration
    • Sensor Activation
    • Data Reception
    • Sensor Installation
    • Receiver Settings
      • Modbus Receiver Communication Settings
      • BACnet Receiver Communication Settings
      • HTTP Receiver Communication Settings
    • Receiver Connection to the Controller
      • ⚠️Recommendations
    • Troubleshooting
  • TX IO INSTALLATION
    • Installation Procedure
      • Reminder
      • Remote control mode
      • Local control mode
      • D2D mode
  • TX MODBUS INSTALLATION
    • Installation Procedure
      • Reminder
      • Configuration
      • Activation of TX MODBUS
      • Checking
  • 📂Appendices
    • 📎Best Radio Practices
    • 📎Communication Modes
    • 📎Using the Push Button
    • 📎LED Sequence Meanings
      • Sensors
      • TX IO
      • TX Modbus
      • Receivers
      • Repeater
    • 📎CO2 Sensor Calibration
    • 📎Wiring
      • Wiring Diagrams
        • RX MODBUS 500-302
        • RX BACNET 500-312
        • TX MODBUS 600-041
        • TX IO 600-040
      • Pulse sensors wiring
        • TX PULSE
        • TX PULSE LED
      • 4/20mA Probe Wiring
    • 📎RESET to Factory Settings
    • 📎Repeater Installation
    • 📎Sensor Update
    • 📎Batteries
      • Battery Lifespans
      • Battery Replacement
    • 📎Generic Information
      • Covered products
      • Safety
      • Labels
      • CE Conformity
      • Contact
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. 📂Appendices
  2. 📎Wiring
  3. Wiring Diagrams

TX IO 600-040

TX IO 600-040 Wiring Diagram

PreviousTX MODBUS 600-041NextPulse sensors wiring

Last updated 5 months ago

Was this helpful?