Installation Steps

Take a step back to get an overview of the installation steps and the equipment you'll need

Installation steps

IP Configuration

Configure the PC's IP settings to be able to access the receiver's configuration server.

Server access

Preparing the receiver (antenna, power supply) before accessing the configuration server.

Configuring sensors

Registration and configuration of the sensors you wish to pair with the receiver.

Activation of sensors

Powering the sensors so they can pair with the receiver and retrieve their configuration settings.

Data reception

Validation that the sensors are communicating properly with the receiver and that the RSSI is good.

Installation of devices

On-site installation of the products following our best practices.

Receiver settings

Configuration of the receiver communication settings before connecting to the BMS.

Connection to PLC

Wiring and connection guide for your receiver to the controller / BMS.

The TX IO and TX MODBUS have specific installation procedures. Please refer to the table of contents to access the installation procedures for these products.

Required Equipment

PC with ethernet port

Use an Ethernet-to-USB adapter if your PC does not have an Ethernet port

Long range antenna for the receiver

Use the Enless Long Range Antenna

Power supply for the receiver

Power the receiver with 7.5 to 24VDC.

Enless 12V power supply available

Screwdrivers

1x Phillips screwdriver

1x flathead screwdriver (ø 2.5mm)