BACnet Receiver Communication Settings

Configure the BACnet receiver communication settings from the CONFIG RX tab

Configuring BACnet settings

The configuration of the BACnet receiver parameters is done from the CONFIG RX tab

Field	Meaning
Baud rate, Data and stop bits, Parity	Match the receiver's communication parameters with those of your PLC (valid for BACnet MSTP communication).
Device mode	Each sensor paired to the receiver will appear as a BACnet device on the network during discover. Only objects from sensors paired to the receiver will be accessible after the discover.
Object mode	The receiver will display any BACnet objects it may contain during discover.
Protocole	Select the desired communication protocol: MSTP IP MSTP + BBMD IP+ MSTP
DHCP	You can enable (or not) DHCP
Other settings	Additional parameters (IP address, subnet mask, gateway, UDP port...)