Modbus receiver communication parameters

Configure the Modbus receiver communication parameters from the CONFIG RX tab

---

Configuring Modbus parameters

Configuration of the Modbus receiver parameters is done from the CONFIG RX tab

Field	Meaning
Baud rate, Data and stop bits, Parity	Match the receiver's communication settings with those of your controller.
Modbus ID	Modbus ID of the receiver.
1st register	Register number from which the sensor information will be incremented in the Modbus table.
RS232 / RS485	Determine the receiver's communication interface when you want to communicate via Modbus RTU: RS232 or RS485
Advanced settings	IP parameters for Modbus TCP/IP communication

Viewing the Modbus table

Once the receiver configuration is complete, you can click on the MODBUS tab to access the receiver table. When you select a transmitter on the left of the screen, the registers in which its information is stored are displayed in the Modbus Table. You can save this Modbus table with the “Export CSV»

Modbus table Excel file

The Excel file detailing the receiver's Modbus table is available below.

60KB

EN_EU868_Enless_Receiver_Modbus_Table_Rev 10_02-.xlsx

55KB

EN_US915_Enless_Receiver_Modbus_Table_Rev 1_0.xlsx

We recommend that the Modbus request frequency on our Modbus receivers falls no lower than 5 seconds between each request.