Installation guide LoRa proprietary
  • Installation help guide
  • About proprietary LoRa
  • Installation steps
  • Installation
    • IP Configuration
    • Access to the server
    • Receiver update (optional)
    • Configuring sensors
    • Activation of sensors
    • Data reception
    • Installation of devices
    • Receiver settings
      • Modbus receiver communication parameters
      • BACnet receiver communication parameters
    • Connecting the receiver to the PLC or the BMS
    • ⚠️Recommendations
  • INSTALLATION TX IO
    • Installation procedure
      • Reminder
      • Remote control mode
      • Local control mode
      • D2D mode
  • INSTALLATION TX MODBUS
    • Installation procedure
      • Reminder
      • Configuration
      • Activation of TX MODBUS
      • Checking
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎LED behavior
      • 🖇️Sensors
      • 🖇️TX IO
      • 🖇️TX Modbus
      • 🖇️Modbus & BACnet receivers
      • 🖇️Repeater
    • 📎Communication mode
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Repeater installation
    • 📎RESET factory settings
    • 📎Wiring diagrams
      • RX MODBUS 500-302
      • RX BACNET 500-312
      • TX MODBUS 600-041
      • TX IO 600-040
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. 📂Appendices

📎CE declaration

111KB
DT 39 - CE DECLARATION OF CONFORMITY.pdf
pdf
PreviousBattery replacementNextContact

Was this helpful?