Installation guide LoRa proprietary
  • Installation help guide
  • About proprietary LoRa
  • Installation steps
  • Installation
    • IP Configuration
    • Access to the server
    • Receiver update (optional)
    • Configuring sensors
    • Activation of sensors
    • Data reception
    • Installation of devices
    • Receiver settings
      • Modbus receiver communication parameters
      • BACnet receiver communication parameters
    • Connecting the receiver to the PLC or the BMS
    • ⚠️Recommendations
  • INSTALLATION TX IO
    • Installation procedure
      • Reminder
      • Remote control mode
      • Local control mode
      • D2D mode
  • INSTALLATION TX MODBUS
    • Installation procedure
      • Reminder
      • Configuration
      • Activation of TX MODBUS
      • Checking
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎LED behavior
      • 🖇️Sensors
      • 🖇️TX IO
      • 🖇️TX Modbus
      • 🖇️Modbus & BACnet receivers
      • 🖇️Repeater
    • 📎Communication mode
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Repeater installation
    • 📎RESET factory settings
    • 📎Wiring diagrams
      • RX MODBUS 500-302
      • RX BACNET 500-312
      • TX MODBUS 600-041
      • TX IO 600-040
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. INSTALLATION TX MODBUS

Installation procedure

Find out how to install the TX Modbus

PreviousD2D modeNextReminder

Last updated 6 months ago

Was this helpful?

Sections

Cover

Reminder

Configuration

Activation of TX Modbus

Checking

Cover
Cover
Cover