Activation of sensors
Power the sensors so they pair with the receiver.
Step 1 : Open the sensor housing
Open the sensor boxes that you have just declared and that you wish to activate.


Step 2 : Power the sensors
Power the first sensor (of your choice) by connecting the Molex connector.
Monitor the sensor LED behavior. A LED L3 fixed will confirm that the sensor is correctly paired to the receiver. Repeat for all sensors to activate.
Step 3 : Validate sensor activation from the server
In the CONFIG TX tab, refresh the page in your browser.
A validation sticker should appear in front of the sensor(s) you have just activated. A red dot means that the configuration is being recovered. Do not hesitate to wait a few moments and refresh your page if the green dots do not appear.
Last updated
Was this helpful?