Installation steps

Installation Steps and required materials

---

Installation steps

IP Configuration

Configure the PC's IP settings to be able to access the receiver's configuration server.

Server access

Preparation of the receiver (antenna, power supply) before accessing the configuration server.

Configuring sensors

Declaration and configuration of the sensors you wish to pair with the receiver.

Activation of sensors

Powering the sensors so that they pair with the receiver and recover their configuration parameters.

Data reception

Validating that the sensors communicate correctly with the receiver and that the RSSI is good.

Installation of devices

Installation of devices on site following our best practices.

Receiver settings

Configuration of receiver communication parameters before connecting to the BMS

Connection to PLC

Guide to connecting and wiring your receiver to the PLC/BMS.

The TX IO and TX MODBUS have specific installation procedures. Please refer to the summary for installation procedures for these products.

Necessary material

PC with ethernet port

Use an ethernet/USB adapter if your PC does not have an ethernet port

Long range antenna for the receiver

Use the Enless Long Range Antenna

Power supply for the receiver

Power the receiver with 7.5 to 24VDC.

Enless 12V power supply available

Screwdriver

1x Phillips screwdriver

1x flat screwdriver (ø 2.5mm)