BACnet receiver communication parameters

Configure the BACnet receiver communication parameters from the CONFIG RX tab

If you want to configure a Modbus receiver, go to the Modbus receiver communication settings page .

Configuring BACnet settings

The configuration of the BACnet receiver parameters is done from the CONFIG RX tab

Field
Meaning

Baud rate, Data and stop bits, Parity

Match the receiver's communication parameters with those of your PLC (valid for BACnet MSTP communication).

Device mode

Each sensor paired to the receiver will appear as a BACnet device on the network during discover. Only objects from sensors paired to the receiver will be accessible after the .

Object mode

The receiver will display any BACnet objects it may contain during .

Protocole

Select the desired communication protocol:

  • MSTP

  • IP

  • MSTP + BBMD

  • IP+ MSTP

DHCP

You can enable (or not) DHCP

Other settings

Additional parameters (IP address, subnet mask, gateway, UDP port...)

PreviousModbus receiver communication parametersNextConnecting the receiver to the PLC or the BMS

Last updated

Was this helpful?