Installation guide LoRa proprietary
  • Installation help guide
  • About proprietary LoRa
  • Installation steps
  • Installation
    • IP Configuration
    • Access to the server
    • Receiver update (optional)
    • Configuring sensors
    • Activation of sensors
    • Data reception
    • Installation of devices
    • Receiver settings
      • Modbus receiver communication parameters
      • BACnet receiver communication parameters
    • Connecting the receiver to the PLC or the BMS
    • ⚠️Recommendations
  • INSTALLATION TX IO
    • Installation procedure
      • Reminder
      • Remote control mode
      • Local control mode
      • D2D mode
  • INSTALLATION TX MODBUS
    • Installation procedure
      • Reminder
      • Configuration
      • Activation of TX MODBUS
      • Checking
  • 📂Appendices
    • 📎Applicability
    • 📎Safety
    • 📎Labels
    • 📎LED behavior
      • 🖇️Sensors
      • 🖇️TX IO
      • 🖇️TX Modbus
      • 🖇️Modbus & BACnet receivers
      • 🖇️Repeater
    • 📎Communication mode
    • 📎CO2 sensor calibration
    • 📎Wiring to meters
      • 📎TX PULSE
      • 📎TX PULSE LED
    • 📎4/20mA probe wiring
    • 📎Repeater installation
    • 📎RESET factory settings
    • 📎Autonomy of batteries
    • 📎Battery replacement
    • 📎CE declaration
    • 📎Contact
Powered by GitBook
On this page

Was this helpful?

Export as PDF
  1. Appendices
  2. LED behavior

Repeater

Behavior of the signal repeater LEDs

LEDs on the electronic card

LED
Comportement
Signification

A

Flash

The repeater has received a message

B

Flash

The repeater has transmitted a message

C

ON

The repeater is correctly powered

LEDs outside the product

LED
Behavior
Meaning

Exterior red

Flash Every 1 minute

The repeater is in operation

PreviousModbus & BACnet receiversNextCommunication mode

Last updated 1 year ago

📂
📎
🖇️
  • LEDs on the electronic card
  • LEDs outside the product