Configuring sensors
Declare and configure sensors from the CONFIG TX tab
Last updated
Was this helpful?
Declare and configure sensors from the CONFIG TX tab
Last updated
Was this helpful?
If you wish to configure a TX IO or a TX MODBUS , please refer to the specific installation procedure for these products (see left menu).
Only those receivers with firmware version X.X.8864 and above can manage 50 sensors. Previous versions can manage 40 sensors.
As shown in the above video, once we have accessed the configuration server, the declaration of sensors is done from the tab CONFIG TX by clicking on the button +Add Sensor.
Below are the details of the configuration parameters:
Choose the sensor type
Indicate the location of the sensor (e.g. office)
Enter the LoRa ID (provided on the sensor label).
Choose the transmission periodicity.
The transmission periodicity directly influences the battery autonomy of the products.
Show advanced settings.
Repeat for all sensors to configure.
The list of sensors you have declared is displayed on the CONFIG TX page.
You can resume the configuration of a sensor at any time or delete it using the edit or delete buttons.
We recommend exporting your configuration file in CSV format to preserve your configuration.
Type TX
Location
LoRa ID
Periodicity
+ Advanced
